HARD DRIVE CENTRIFUGE FOR SENSITIZING COPPER CLAD BOARDS

We would wager that most of the home etched PCB projects we see around here use the toner transfer method. but the next most popular technique is to use photosensitive ink which resists the etching acid once it has been exposed to light. most people buy what are called pre-sensitized boards, but you can also get ink to make your own. [Jardirx] does this, and uses an old hard drive to apply an even layer of the light-sensitive ink.

The narration and subtitles of the video found after the break are both in Portuguese, but it’s not hard to figure out what’s going on here. He begins by using double-sided foam tape to secure the piece of copper clad board to the hard drive platters. You’ll want to center it as best as you can to keep the vibrations to a minimum. From there [Jardirx] applies a finishing of the ink using a brush. The image above is what results. So as not to get ink everywhere, he then lowers a soda bottle with the bottom cut off to catch the excess. Power up the drive for a few seconds and the board will have a nice even layer ready for a trip through a UV exposure box.

[Thanks Daniel]